Spod 1997-2002 Instructions Center Bracket Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Spod 1997-2002 Instructions Center Bracket. sPOD 1997-2002 Instructions Center Bracket User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 5
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Installing electrical accessories in any vehicle can
be challenging. Add the limited areas to work with
in a Jeep, and it's even tougher. Another thing to
consider is the possibility of causing serious
damage to a vehicle's factory electrical system if
you tie into the wrong wire or circuit. Thinking
twice about that wiring job now? ......Don't, S-Pod
manufactures a complete stand-alone system
that's worry-free and simple to install!
The heart of the system is the Power Distribution /
Relay Center. This box contains the circuitry to
make it happen, six ATO fuses, Bosch relays,
integrated low voltage protection, and an inline 50
amp resetting circuit breaker. The S-Pod package
is "Plug & Play" with high quality Deutsch
connectors, easy to follow instructions and
everything needed to complete the install.
With the S-Pod system in place, you'll have 6
separate circuits ready for your accessories.
Product image
Installation:
1) Disconnect the negative, then positive terminals and
remove the battery (photo 1).
Photo 1
2) Swing the sun visors to the sides and remove the plastic
windshield header by pulling it outward to release the 5
retaining clips (photo 2).
Photo 2
Zobrazit stránku 0
1 2 3 4 5

Shrnutí obsahu

Strany 1 - Photo 2

Installing electrical accessories in any vehicle can be challenging. Add the limited areas to work with in a Jeep, and it's even t

Strany 2 - Photo 7

3) Remove the passenger sun visor (photo 3). Photo 3 4) Loosen, but do not remove the 3 attaching screws on the passenger side pillar cover (ph

Strany 3

8) Route the wires to the passenger side and down the pillar through the dash (photo 8). Then re-tighten 3 pillar screws loosened in step 4 & re-

Strany 4

12) Re-install the battery (photo 12). Photo 12 13) Remove the 4 screws attaching the power source to the mounting bracket (photo 13). Photo 13

Strany 5 - After installation

After installation !!!Must start engine to activate system!!! 18) Connect positive, then negative terminals to battery (photo 18). Photo 18 19)

Komentáře k této Příručce

Žádné komentáře